Now we need to connect each junction to some connectors. Once you get the junctions on the schematic, then you go ahead and click on our wire tool.And now we just click each Pin 3 on our switches.Now we need to add some junctions to each of the Pin 3's of our switches. Next using the wire tool from before connect the grounds to the resistors then the resistors to leg 3 on each of the switches.Don't forget to give each resistor a 330 ohm value. You can add them to the schematic under the switches similar to what is shown. Use the ADD tool go to: supply1>GND, for your grounds and resistor>RE_U>RE_U_0207/10 for your resistors. We need to add more grounds and resistors to them before we can do anything else. Now that we have all of our LED's ready to go we then can focus on the switches.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |